Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-28 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Coolant Heater Removal/Installation (Cont) Refill engine coolant as required Refer to Drain and Flush Coolant System in Section 5. Install the coolant system pressure cap (Cummins Fire Power Part No. 11407). For safety reasons, both batteries must be re- connected before putting the engine and fire protection system controller back in service. Wear safety glasses when reconnecting batteries! Reconnect the batteries at their terminals after all service work has been completed. NOTE : Start the engine and do a quick check for leaks.

If any coolant leaks are observed, stop the engine, repair the leak, check coolant level, then restart the engine. Start the engine. Refer to Normal Local Starting Procedure in Section 3. Check for and repair any coolant leaks. Stop the engine. WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap (Cummins Fire Power Part No. 11407). Heated coolant spray or steam can cause personal injury. Check the coolant level. Refer to Check Coolant Level in Section 5. Add coolant if necessary. Reconnect the coolant heater power supply. Observe that the coolant temperature cools down but stabilizes.

Check that the engine block remains warm to the touch. Drawing No. 9777, Section 7, Rev. 02-07