Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7– Adjustment, Repair, and Replacement Page 7-71 CFP83 Series Alternator Removal/Installation (Cont) NOTE : Refer to Drawing 8513 Sheet 1 in Section 13 for wiring harness information. Follow-Up Connect the engine wiring harness connectors to the alternator. Install the drive belt. Refer to Belt Removal/Installation in this section. Install the belt guard. Refer to Belt Guard Removal/Installation in this section. Drawing No. 9777, Section 7, 02-07 Install Position the alternator on the bracket, and secure it with the mounting capscrews. Do not tighten at this time. Connect the alternator link to the alternator. Finger-tighten the capscrews. NOTE:

Make sure the alternator link is properly positioned for correct belt alignment. Tighten the alternator mounting capscrews. To install the alternator, the alternator mounting components must be tightened in the following sequence: 1. Alternator-to-alternator bracket capscrew Torque Value: 43 N•m [32 ft-lb] 2. Lower brace-to-alternator capscrew Torque Value: 24 N•m [18 ft-lb]