Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 7 – Adjustment, Repair, and Replacement Page 7-103 CFP83 Series Inline Fuel Injection Pump Removal/Installation Refer to Fuel Injection Pumps, In-Line (41-005-012) in C Series Troubleshooting and Repair Manual, Bulletin No. 3666003. Prepare Clean debris. Remove all fuel lines. Remove control linkage. Remove fuel shutoff solenoid. Remove AFC air line. Remove oil line(s). Remove CAUTION A diesel engine can not tolerate dirt or water in the fuel system. A tiny piece of dirt or a few drops of water in the injection system can stop the unit. Clean all external surfaces of the injection pump, including all line connections and fittings that are to be disconnected.

Clean the area around the injection pump gear cover to prevent dirt from entering the crankcase. Locate top dead center for cylinder No. 1. Push the top dead center pin into the hole in the camshaft gear while slowly barring the engine. NOTE : Be sure to disengage the pin after locating top dead center. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a 1/2-inch ratchet or breaker bar. Drawing No. 9777, Section 7, Rev. 02-07