Page 2-10 Section 2 – Engine Identification CFP83 Series Fire Pump Engine Data Tag Factory Setting Tag Drawing No. 9777, Section 2, Rev. 02-07 The Fire Pump Engine Data Tag is located at the pump end of the engine just above the redundant starter solenoids. Refer to Drawing 8708 (CFP83-F10, F20, F30) or Drawing 8710 (CFP83-F40) in Section 13 for location details. This tag shows specific information about your engine. The engine serial number provides information for ordering parts and service needs. NOTE: The fire pump dataplate must not be changed unless approved by Cummins Fire Power.
The Factory Setting Tag is located at the pump end of the engine just above the redundant starter solenoids. Refer to Drawing 8708 (CFP83-F10, F20, F30) or Drawing 8710 (CFP83-F40) in Section 13 for location details. This tag identifies to rated operating speed at the rated horsepower. It also provides the over speed switch setpoint. Both values are set at the factory. Refer to Installation Instructions in Section 3 for procedures to verify or adjust either setpoint. FACTORY SETTING