Page 7-112 Section 7 – Adjustment, Repair, and Replacement CFP83 Series Fuel Injection Pump, In-Line, Spill Port Timing (Cont) Remove the fuel pump mounting bracket. Remove the gear cover access cap. Remove the nut and washer from the fuel pump shaft. Pull the fuel pump drive gear loose from the shaft. Remove the four mounting nuts. Remove the fuel pump. Install Make sure the engine has cylinder No. 1 at top dead center. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a 1/2-inch ratchet or breaker bar. Drawing No. 9777, Section 7, Rev. 02-07