Section 7 – Adjustment, Repair, and Replacement Page 7-115 CFP83 Series Fuel Injection Pump, In-Line, Spill Port Timing (Cont) CAUTION The fuel pump drive inside diameter and the shaft outside diameter must be clean and dry before installing the shaft into the gear. A non-petroleum-based cleaner can be used to clean the drive gear and shaft mounting surfaces. Failure to do so will result in gear slippage in the retarded direction. Clean the drive gear and shaft with a non- petroleum-based cleaner. NOTE : If the mounting flange o-ring has a colored stripe, it can not be reused. Replace with a new o-ring. Furthermore, do not lubricate the new-type o-ring.
Instead, lubricate the seating area of the gear housing. Lubricate the mounting flange of the fuel injection pump with clean lubricating engine oil. NOTE : The P7100 fuel injection pump driveshaft has a provision for a Woodruff key; however, it is not required for the P7100 drive gear. Slide the pump shaft through the drive gear, and position the pump flange onto the mounting studs. Push the pump forward until the mounting flange and o-ring are properly fitted into the gear housing bore. If equipped, finger-tighten the capscrews for the support bracket. Tighten the mounting nuts. Torque Value: Mounting Nuts 44 N•m [32 ft-lb] Drawing No. 9777, Section 7, Rev. 02-07