Section 7 – Adjustment, Repair, and Replacement Page 7-121 CFP83 Series Fuel Shutoff Valve Removal/Installation (Cont) Install Install new insulating tubes onto the terminals on the terminal studs of the new solenoid. Install the valve into the cover. Torque Value: 14 N•m [124 in-lb] Install the cover and gasket onto the fuel injection pump. NOTE : Extreme care must be taken in assembling the cover to the fuel injection pump to make sure the shutoff arm is in proper contact with the linkage hook tab. Install the cover to the pump at a downward angle from the driveshaft end of the fuel injection pump; then slide the cover horizontally into position. Torque Value: 5 N•m [44 in-lb] Drawing No.
9777, Section 7, Rev. 02-07