Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 7-146 Section 7 – Adjustment, Repair, and Replacement CFP83 Series High Pressure Injector Supply Lines Removal/Installation Refer to Injector Supply Lines (High Pressure) (41-006-051) in C Series Troubleshooting and Repair Manual, Bulletin No. 3666003. Prepare Clean all debris from around the fittings. Remove Rotary Pumps Disconnect the fuel line(s) from the injector. NOTE : If individual lines are to be replaced, remove the support clamp from the set of lines containing the line to be replaced. Disconnect the fuel line(s) from the fuel pump. Install protective covers onto the injectors and delivery valves to prevent entry of dirt into the system.

Remove Inline Pumps Disconnect the line(s) from the injector(s). NOTE : If individual lines are to be replaced, remove the support clamp from the set of lines containing the line to be removed. Disconnect the line(s) from the fuel pump. Drawing No. 9777, Section 7, Rev. 02-07