Section 7 – Adjustment, Repair, and Replacement Page 7-151 CFP83 Series Air Leaks, Air Intake and Exhaust Systems Checks (Cont) Operate the engine at full throttle and rated rpm with maximum load. Listen again for leaks. Replace the turbocharger if the air piping is not damaged and the noise can still be heard. Refer to Procedure 010-033. Loose connections or cracks in the suction side of the intake pipe and after the air filter can allow debris to be ingested by the engine, causing rapid wear in the cylinders. Leaks at the intake manifold, unsealed bolt holes, or manifold cover gasket can also allow dust and dirt to be ingested into naturally aspirated engines.
Debris drawn into the air suction side can damage the compressor blades, causing an imbalance resulting in bearing failure. To verify a bearing failure or damaged compressor, remove the intake and exhaust piping, and check for contact. The rotor assembly must rotate freely and should not be damaged. Measurement of axial and radial clearance is described in this section. Excessive smoke and low power from a turbocharged engine can be caused by pressurized air leaking from loose connections or cracks in the crossover tube or intake manifold. This can also cause a noise problem. Drawing No. 9777, Section 7, Rev. 02-07