Section 7 – Adjustment, Repair, and Replacement Page 7-173 CFP83 Series Turbocharger Axial Clearance Check Prepare Axial Clearance Check Use dial depth gauge, Part Number ST-537. Push the rotor assembly away from the gauge. Set the gauge to zero. Push the rotor assembly toward the gauge and record the reading. Axial Clearance Minimum 0.038 mm [0.0015 in] Maximum 0.093 mm [0.0037 in] Replace the turbocharger if the clearance does not meet specifications. See the Remove and Install steps in this procedure. Follow-Up Drawing No. 9777, Section 7, Rev. 02-07