Page 3-8 Section 3 – Installation and Operation CFP83 Series Raw Water Supply Installation (Cont) Raw Water Supply & Drain without Cummins Raw Water Manifold (CFP83-F40 Only) NOTE : Raw water outlet piping from the heat exchanger should be one pipe size larger than the supply piping. NOTE : The velocity of raw water should be as great as possible without exceeding the maximum shown on the appropriate engine data sheet. NOTE : Failure to comply will result in engine overheat and failure. Provide raw water supply to the Charge Air Cooler water inlet. Provide an open waste cone raw water drain at the outside of the heat exchanger.
Raw Water Supply and Drain with Cummins Raw Water Manifold NOTE : Raw water outlet piping from the heat exchanger should be one pipe size larger than the supply piping. NOTE : The velocity of raw water should be as great as possible without exceeding the maximum shown on the appropriate engine data sheet. NOTE : Failure to comply will result in engine overheat and failure. Provide raw water supply to the raw water manifold inlet. Provide an open waste cone raw water drain at the outside of the heat exchanger. Drawing No. 9777, Section 3, Rev. 02-07