Page 12-50 Section 12 – Troubleshooting CFP83 Series Engine Noise Excessive — Combustion Knocks Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Engine is overloaded. Check for added mechanical loading from damaged or defective pump, changes in suction head, or changes in discharge piping restriction. Fuel grade is not correct for the application or the fuel quality is poor. Operate the engine using the correct fuel. Refer to Fuel Recommendations and Specifications in Section 10. Air is present in the fuel supply to the engine. Check for air in the fuel system. Tighten or replace the fuel connections, fuel lines, fuel tank standpipe and fuel filters as necessary.
Vent air from the system. Refer to Air in Fuel in Section 7. Fuel injection pump timing is not correct. Put the engine at top dead center. Check and adjust the fuel timing. Refer to Fuel Injection Pumps, In-Line (005-012) or Fuel Injection Pump, In-Line, Spill Port Timing (005-013) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Fuel injection pump is malfunctioning. Replace the fuel injection pump. Refer to Fuel Injection Pumps, In-Line (005-012) or Fuel Injection Pump, In-Line, Spill Port Timing (005-013) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Coolant temperature is below specification.
Refer to the Coolant Temperature Below Normal (Engine Running) symptom tree in this section.