Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 12-52 Section 12 – Troubleshooting CFP83 Series Engine Runs Rough at Idle NOTE: Operation at idle speed is for maintenance only. Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction The engine is cold. Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal (Engine Running) symptom tree. Idle speed is set too low. Check and adjust the low-idle screw. Refer to Fuel Pump Idle Speed (005-029) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Engine mounts are worn, damaged, loose, or not correct. Verify the condition of the mounts.

Refer to Engine Mounts (016-010) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Air is present in the fuel system. Bleed the fuel system and check for suction leaks. Refer to Fuel Supply Lines (006-024) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Fuel filter is becoming plugged. Replace the fuel filter. Refer to Change Fuel Filter in Section 7. Fuel supply to the engine is inadequate. Locate and correct the restriction in fuel flow to the engine.