Page 12-58 Section 12 – Troubleshooting CFP83 Series Engine Speed Surges at Idle NOTE: Operation at idle speed is for maintenance only. Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Fuel level is low in the tank. Fill the fuel tank. Fill and bleed the fuel lines to the engine. Idle speed is set too low. Check and adjust the low-idle screw. Refer to Fuel Pump Idle Speed (005-029) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Air is in the fuel supply to the engine. Check for air in the fuel system. Tighten or replace the fuel connections, fuel lines, fuel tank standpipe and fuel filters as necessary. Vent air from the system.
Refer to Air in Fuel in Section 7. The fuel filter is plugged. Replace the fuel filter. Refer to Change Fuel Filter in Section 7. Fuel flow to the engine is not adequate. Locate and correct the restriction in the customer- supplied fuel lines to the engine. Fuel grade is not correct for the application or the fuel quality is poor. Operate the engine with the required fuel. Refer to Fuel Recommendations and Specifications in Section 10. A fuel supply line restriction exists between the fuel injection pump and the injectors. Check the fuel supply line or passage for sharp bends or restriction. Remove any restrictions.