Section 50 - Climate Control - Chapter 1 Electrical Test See Electrical Schematic sections 60, 61, 6 at the end of this section. Background The compressor clutch is cycled On or Off by the controller based on the difference between the selected cab temperature setpoint and the temperature sensed at the cab temperature sensor. When functioning normally, the clutch is always grounded to the engine through the compressor mounting bracket. The controller grounds the compressor clutch relay to provide 12V from fuse 36 to energize the clutch coil and engage the compressor.
Power and Ground Circuit Switched 12V is fed to the compressor clutch relay on pin 3 through pin 17 switched power at ATC Controller. The controller energizes the relay by supplying power through pin 15 to pin 2 on the clutch relay. 12V is fed from pin 5 on the relay - through C139-C, C333-26, and C60-P - to energize the clutch coil at C72-1. Possible Failure Modes: 1. Short circuit or open circuit in clutch coil. 2. Open circuit in power or ground between controller and relay. 3. Open circuit in power and ground between clutch and relay. 4. Controller fault. Compressor Clutch Control Circuit Test Procedure 50-1-36 Steps and Test Point Corrective Actions NOTE:
This procedure assumes that the clutch has NOT been latched OFF by the controller due to high or low pressure switch activation and that no fault codes are displayed on the Instrument Cluster Display. RI01H035 1. Keyswitch and ATC switch OFF. Test continuity between clutch screw and ground screw on compressor mounting bracket. Less than 1 ohm? YES - Go to next Step. NO - Repair open circuit or replace wire. Retry the unit. NOT OK - Go to next Step.