CNH T8000 — DIFFERENTIAL INSTALLATION

Section 25 - Four-Wheel Drive Front Axle - Chapter 8 DIFFERENTIAL INSTALLATION STEP 71 STEP 73 RR98K047 Install ring gear and differential assembly with bearing cups into carrier housing. RR98K015 Be sure bearing cups are seated on bearing cones, then install differential bearing caps. Install bearing cap bolts (finger tight only) so adjusting nut can still be turned. (Do not torque cap bolts to specifications). IMPORTANT: Care should be used when installing ring gear and differential into carrier housing so damage to ring gear, pinion bearings, or bearing bore does not occur. NOTE: Make sure the “match marked” bearing cap and “match marked” leg of the carrier are aligned.

STEP 72 STEP 74 1 2 1. BEARING CUP 2. ADJUSTING RING RR98K016 Install adjusting rings in place. Thread in adjusting rings until all slack is removed between bearing cups and bearings. 1. DIAL INDICATOR 2. ADJUSTING RING RD99C141 Position a dial indicator on the housing lip and index indicator dial to back face of the ring gear. Zero the indicator. NOTE: Adjusting rings must be installed with side of nut having the deeper recess facing the bearing. Installed opposite, the adjusting ring would clamp against the bearing cage restricting movement. Turn adjusting ring on the backside (flange side) of the ring gear in until the indicator stops moving. (Ring gear is moved into mesh with pinion).

25-8-22 1 2