CNH T8000 — PLANETARY HUB ASSEMBLY

Section 25 - Four-Wheel Drive Front Axle - Chapter 10 STEP 110 STEP 113 RD05D241 Place the large aluminum pilot tool onto the bearing cup with the small pilot diameter facing up. Push the hub (by hand) onto the spindle until contact with the seal is made. The threaded rod should be exposed. RD04D245 STEP 111 STEP 114 1 RD05D242 Align the flat bar with the small pilot diameter (1) and fasten to the adapters using the bolts provided. Install a washer and nut onto the threaded rod. RD04D246 STEP 112 STEP 115 RD04D243 Use a hoist (or other suitable means) and lift the hub with mounted alignment tools and align with the spindle.

Tighten until a noticeable increase in torque is required to turn the nut. At this point the seal should be fully seated. RD04D247 25-10-32