Section 35 - Hydraulic Systems, 3PT - Chapter 1 Valve A Valve C This valve is a three position valve. The spool is lever operated and spring centered. It is an open center valve. Visually place the envelopes into the center position and you will see that the valve will direct oil into one end or the other of cylinder A. When the spool in valve A is moved out of the centered position, the valves downstream will receive no oil. This valve is also similar to valve A but is designed to control a single acting cylinder. When you visualize placing the upper envelope in the center position you will see that oil can drain back to the reservoir from cylinder C.
Valve B At the same time, oil from the pump can flow through valve C to the next valve. Valve D Valve B is similar to valve A but it is a four position valve. The fourth position is a float position and is held into that position with a detent. With this valve the cylinder B can be extend, retracted, or placed in the float position. Visualizes the envelope for the float position in the inlet passageway. Valve D is a lever operated, spring centered valve and is designed to control a hydraulic motor. If a hydraulic motor was turning a flywheel and the oil supply and return were shut off abruptly, this would cause damage to the hydraulic lines, the motor, or whatever it was powering.
Therefore when the valve supplying the motor is shut off, the motor should be able to slow down gradually. The center (neutral) position of valve D will allow that to happen by letting oil from the outlet of the motor return to the inlet side. You will see that oil can continue to flow to the next valve downstream and that the rod in cylinder B could be pushed back and forth. The oil could move from one end of the cylinder to the other via the valve. Both ends of the cylinder are also connected to the return line to the reservoir. As you have seen, this brief information is all you need to read hydraulic schematics.
The more you use it, the more you will be comfortable using hydraulic schematics as a troubleshooting guide. 35-1-14