Komatsu — AIR CONDITIONER, HANDLING

. OPERATION EXPLANATION OF COMPONENTS PRECAUTIONS WHEN USING of the desiccant has been exceeded, the refrigerant 3 - 68 PRECAUTIONS WHEN USING THE COOLING If you smok e when using the air conditioner in the RECIRC mode, your eyes may start to itch or burn. Ve ntilate the cab eve r so often to remove the smoke. rry out ventilation process at least once every hour. When using the air conditioner for a long period of time, ca rry out ventilation process at least once every When using th e air conditioner, it is recommended for health r easons, that it should only feel slightly cooler ( 5 or 6 °C (9 or 10.8° F) lower than the outside temperature) when yo u enter the cab.

Therefore, adj ust the temperature to a suitable level. SET SO THAT COLD AIR DOES NOT DIRECTLY BLO W ONTO THE GLASS SURFACE If the vents ( left and right) in the middle of the dashboard are turned so that cold air blows directly on the ca b door glass, mois particularly i If this happe on the surfa ture may condense on the outside of the cab n high temperatures.) door glass and reduce the visibility. (This occurs ccurs ns, close the louvers of the vent and change the direction to prevent the cold air from blowing d irectly ce of the glass.

INSPECTION DURING OFF-SEASON Even during th e off-season, run the compressor at low speed for several minutes once a week to prevent th e loss of the oil film o n the lubricated parts of the compressor. ture when carrying out this operation.) (Run the engin e at low speed and set to a mid-range tempera REMARK When the amb ient temperature is low, if the compressor is su ddenly run at high speed, it may cause failure of the compressor. N ote that the system is set so that the compress or will not run when the cooler switch is turned on, if the ambient te mperature is less than 2 to 6.5°C (35.6 to 43.7 °F). PROCEDURE FOR REPLACING RECEIVER Replace the receiver once every 2 years.

Replace the re After replacing the receiver, add compressor oil. Turn the rece iver at an angle and measure the oil remaining inside the receiver, th en add the same amount of oil (Denso Oil 6) t o fill the receiver. REMARK The replac ement interval may become shorter depending If the receiv er is used when the moisture absorption limit circuit may become blocked and cause the compressor to PRECAUTIONS WHEN REPLACING RECEIVER If the receiver is left for more than 15 minutes with the b lind cover removed, the moisture in the air will be If the receiv absorbed, a evacuate th nd this will reduce the life of the desiccant.

If yo u remove the blind cover, connect the piping q uickly, e system and fill with refrigerant. ving the refrigerant from the refrigerant circuit rom flowing out. , release it gradually from the low pressure side to When remo prevent oil f CHECK COMPRESSOR BELT TENSION AND REFRIG If the compres sor belt is loose, or the refrigerant level is low, For details, se e "WHEN REQUIRED (PAGE 4-20)".