Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION OPERATION CHECK BEFORE STARTING ENGINE, ADJUST WARNING system. If any leak is found, repair it. 5. Check the undercarriage (track, sprocket, idler, guard) for damage, wear, loose bolts, or leakage of oil from rollers. If any problem is found, repair it. 6. Check for problems in handrails, steps, loose bolts. If any problem is found, repair it. Tighten any loose bolts. 3 - 70 WALK-AROUND CHECK Before starting the engine, walk aro und the machine and look at the underside of chassis for anything unusual l ike loose bolts and nuts, leakage of fu hydraulic system. el, oil and coolant.

Also check the condition of the work equipment and the nd collection of dust at places that reach high temperature. the Also check for loose wiring, play, a nd collection of dust at places that reach high tempera Leakage of oil or fuel, or accumulati on of flammable material around high temperature parts, su ch as the engine m uffle r or turbocharger, may cause fire. Check carefully, and if any abnormal ity is found, repair it or contact your Komatsu distributor. Do not get on or off the machine fro m the rear. Using this position is dangerous because it is eas y to slip and you c annot be seen from the operator's compartme nt.

Always use the handrail and step at the side when getting on or off the machine. If the machine is at an angle, repos Perform the following inspections a nd cleaning every day before starting engine for the d 1. Check for damage, wear, play i n work equipment, cylinders, linkage, and hoses. Check that there are no cracks, any problem is found, repair it. excessive wear, or play in the work equipment, cylind ers, linkage, or h oses . If 2. Remove dirt and debris from ar ound the engine, battery, and radiator.

Check for dirt accumulated arou etc.) around the battery, engin flammable materials are found, nd the engine and radiator.Also check for flammable m aterial (dry leave s, twigs, e muffler, turbocharger, or other high temperature engine parts. If any dirt or remove them. 3. Checking engine for leak of wa gine oil, leak of water from the cooling system and lea k of air from the suction 4. Check for oil leakage of oil from power train case, final drive case, hydraulic tank, hos Check that there is no oil leaka Check for leakage of oil from th ge. If any problem is found, repair the place where the e undercover. Check the ground for traces of oil leaka 7.

Check for problems in gauges and monitor Check that there is no problem i the parts. Clean off any dirt on n the gauges and monitor in the operator's cab. If any p roblem is found, replace the surface.