Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN POWER TRAIN CASE, ADD OIL WARNING The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Open cover on the right side of the machine. 2. Remove dipstick (G), and wipe the oil off with a cloth. 3. Fully insert dipstick (G) into filler pipe (F), then remove it. 4. The oil level should be between the (H) and (L) marks on dipstick (G). If the oil level is below the (L) mark, add oil through oil filler (F). 5. If the oil level is above the H mark, remove cover (1) on the bottom of the machine.

Loosen drain plug (P), drain the excess oil, then check the oil level again. 6. If the oil level is correct, insert dipstick (G) fully into the dipstick guide again. REMARK If the machine is at an angle, reposition it to level before checking. allow the engine to cool for 15 minutes before checking. CHECK ELECTRIC WIRING CAUTION 3 - 76 When checking the oil l evel after the engine has been opera If the circuit breakers are a ctivated and the fuses are blown frequent ly or there is a trace of short-circuiti ng in the wirings, check the cause immediately and either correct it by yourself or call your Komatsu distributor for the repair.

Keep the top surface of the battery clean and check the breather ho le in the battery cap. If it is clogged with dirt or dust, wash the battery cap to clear the breather hole. Check that the circuit bre akers are in normal condition (with the red button pushed in), tha t the fuses have no damage and fuses of the s pecified capacity are in use and tha t there is no trace of disconnecti on or short-circuiting in the wirings and no dama ge in the covers. Moreover check th e terminals for loosening and reti ghten loosened one, if any. heck the wiring for the battery, starting motor, and alternator. le material is accumulated around the battery, remove it.

n of the cause, please contact your Komatsu distributor. Be particularly careful to c heck the wiring for the battery, start In addition, if any flammab le material is accumulated around t For repairs or investigatio n of the cause, please contact your