Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION (4) Trunnion 0.2 - 1.0 (0.008 - 0.039) 10 (0.4) 2. After the assembly, grease shim adjusting positions (1) to (3) and check that each part turns smoothly. ADJUSTING TENSION OF CENTER BRACE (Power tiltdozer only) (Powertilt, Power pitch dozer only) In case the work equipment assembly is disassembled for transportation and reassembled at a worksite, tension of the center brace has to be adjusted anew. Otherwise the bushing at the connecting part of blade and straight frame will likely slip off, allowing sand and dirt to enter the bushing, which eventually leads to premature wear or damage of the bushing. Make this adjustment as follows:

WARNING 3 - 111 ADJUSTING SHIMS IN ASSEMBLING WORK EQUIPMEN 1. When as sembling the wor k equipme nt, adjust a n amount of play a t each part (C) to the right values shown in the follow ing table. Shim adjusting position Item (1) Tilt (2) Lift (3) Center Optimum value 0. mm (0 (in) 0 2 - 0.5 .008 - .020) 0.2 - 0.5 (0.008 - 0.020) 0.2 - 0.5 (0.008 - 0.020) Thickness of standard shims mm (in) ( 5 0.197) 4 (0.158) 5 (0.197) Except when o perating th e blade i n Step 4, al ways lock th e blade control lever securely with the work e 1. Adjust wi th shim (2 ) so that the play o f ball joint ( 1) is 0 .2 to 0.5 mm (0.0 08 to 0.02 0 in). sembly. control lever to float the blade.

e center brace hole and turn the bar to the t that time, adjust clearance between the 2. Loosen b olt (3). 3. Install th e blade as sembly. 4. Operate the blade control l ever to flo at the blad 5. Insert ba r (4) in th e center brace hol e and turn the protrudin g side. A t that ti me, adjust clearance between the track sho e and fra me (D) s o that it is equal on th e right and lef sides. Rotating torque: 24 .5 to 49 Nm (2.5 to 5 kgm, 18 .1 to 3 6.2 lbft (Blade at FLOAT) Standard distance betwee n the joints (B) is as s hown below. D65EX: 995mm (3 D65PX: 992mm (3 D65WX: 995mm ( 6. Tighten b olt (3). Tightenin 448.4 lbf