Komatsu — ADJUSTING POSTURE OF WORK EQUIPMENT

. OPERATION OPERATION WARNING (I) (J) Left angle : 25 ° Right angle: 25 ° 1. Raise the blade up to the height of 400 mm to 500 mm (15.8 in to 19.7 in) above the ground, and put block (B) beneath the blade edge. 2. Remove pins (1) on the left and right sides, then remove arm (2) from the frame. 3. Insert arm (2) into any desired bracket (C) on the frame (three brackets provided on one side) and fasten it with pin (1) so that it does not slip off. 3 - 113 METHOD OF ANGLING BLADE Angledozers onl When dozin g toward one side only , operate with angled blade. When adjusting amount of angling, it is the work equipment is m oved by mistake.

S et the work e quipment in a safe condition, t hen stop the e ngine and lock the work equipmen t securely with the work e quipment lock l ever. Be careful whe n removin g arm (2). After arm (2) is removed, the blade can move f reely