Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION LOADING, UNLOADING WORK WARNING ° or less. ramps. In addition, and the machine is "STARTING IN COLD 3 - 122 Since loading and unloading of the machine is dangerous, be extremely c areful. When loading or unloading the ma chine, operate it slowly with the engine speed low and the transmi Use ramps having sufficient width, length, thickness, and strength. Install them securely and set thei If the ramps are deflected apprecia bly, reinforce them with blocks. Perform the loading work of the ma chine on firm, level ground. Secure sufficient distance between the s the trailer.

Remove mud from the undercarria ge of the machine so that the machin e will not slip sideways on remove water, snow, ice, grease, o il, etc. from the ramps. Never steer the machine on the ra mps, since steering on the ramps can c ause the machine to tip o change the travel direction, return to the ground or to the bed of the traile r, then change the travel dir The center of gravity of the mac hine shifts suddenly at the border unbalanced and becomes dangero us. Accordingly, pass the border slowly When loading or unloading, alwa ys use ramps or a platform. Procee LOADING WORK l ground only. the edge of a road. 1. 2. 1. Load and unload on firm leve Maintain a safe distance from 2.

Apply the trailer brakes secur ely and put blocks (1) under the tires to hold the trailer in posi tion.Set gap (3) between ramps (2) to match the distance betw een the left and right tracks, and keep angle (4) to a maximum of 15°. If ramps (2) bend appreciably under the weight of the machine, put wooden block (5) under th e ramps to support them. 3. Start the engine. In a cold weather, carry ou t an engine warming-up run, referring to the section, "S this manual. FREE position (F). t gear and run the engine at low the ramps and drive slowly. machine shifts suddenly at the and trailer, and the machine is ngerous. Accordingly, pass the ified position on the trailer. WEATHER (PAGE 3-93)", in 4.

Set parking brake lever to the 5. Set the transmission in the 1s idle. 6. Set the travel direction toward 7. The center of gravity of the machine shifts suddenly at the border between the ramps unbalanced and becomes da border slowly. and trailer, and the machine is 8. Stop the machine at the spec