. MAINTENANCE GUIDE TO MAINTENANCE CHECK SERVICE METER: Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. KOMATSU GENUINE OILS: For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature. 4 - 2 GUIDE TO M Do not perform any i nspection and maintenance ope ration that is not fo KOMATSU GENUINE REPLACEMENT PARTS: Use Komatsu genuin e parts specified in the Parts Bo ok as replacemen ALWAYS USE CLEA N WASHER FLUID: Use automobile wind ow washer fluid, and be careful not to let any dirt g CLEAN OIL AND GRE ASE: Use clean oil and gre ase.
Also, keep the containers o f the oil and greas e clean. Keep foreig n materials a way from oil and grease. CHECKING FOREIGN MATERIALS IN DRAINED OIL: After oil is changed o r filters are replaced, check the ol d oil and filters for m etal particles and for eign materia ls. If l arge quantity of metal pa suitable action. rticles or foreign materials are found, always report to the person in charge, and carry out harge, carry FUEL STRAINER: If your machine is eq uipped with a fuel strainer, do n ot remove it while f WELDING INSTRUCT IONS: Cut off power. Wa it for approx.
one minute after tu rning off the engin e starting switch key , and then di sconnect the negative (-) te rminal of the battery. than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. Do not apply more Connect groundin g cable within 1 m (3.3 instruments, conn ectors, etc., the instruments may malfunction. If a seal or bearing happens to come between the p art being welded a nd grounding point, change the g rounding point to avoid suc h parts. a around the work equipment pins or the hydraulic cylinders as the grounding point.
Do not use the are a around the work equipment pi ns or the hydraulic cylinders as the gro unding point DO NOT DROP THIN GS INSIDE MACHINE: When opening ins pection windows or the oil filler p ort of the tank to carry out inspection, be careful n ot to drop nuts, bolts, or tool If such things are lead to failure. If y s inside the machine. dropped inside the machine, it m ay cause damage and/or malfunction of the machine , an d will ou drop anything inside the mac hine, always remo ve it immediately. r inspection. Do not put unnece ssary things in your pockets. C arry only things wh ich are necessary fo r inspection. DUSTY WORKSITES: ty worksites, do as follows:
When working at dus Inspect the dust in dicator frequently to see if the ai r cleaner is dirty o Clean the radiator core frequently to avoid cloggin g.