Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING the H line. This will damage the 5 4) Install cap. 4 - 47 The parts and oil are at high tempe rature immediately after the engine is stopped, and may cause burns. Wait for the ng the work. temperatur e to go down before starti When remo ving the oil filler cap, oil m ay spurt out, so push the cap down t o release the inter nal pressure, then r emove the cap carefully. NOTICE Do not add oil if the level is above hydraulic e quipment and cause the o Always loc k the cap with the key. . Lower b lade to the ground and stop the engine. Wait f minutes the H an before checking oil leve l.

Oil level should b e betw d L in sight gauge (G). . If the lev el is below the L mark, add oil through oil f iller (F) down cap of oil filler (F ) to release the air and re move the internal pre cap pushed down, tur n it slowly counterclockwis e, the l the specified quantity of oil through oil fill n installing cap to the ta nk, push it down, t hen tur REMARK not installed correctly, it will cause leakage of oil. If the cap is not installed correctly, it will cause leakage of oil. When install ing the cap, press the c ap down, and turn it until i t is securely in contac t with the stopper The cap is th e lock addition type.

About handli ng method of cap with t he lock, see "CAP WITH LOCK (PAGE 3-50)".