(2) When the engine is working, the temperature of the antifreeze mixture doesn't exceed 90°C so as to avoid the alcohol volatilize. (3 ) test the volume of the antifreeze mixture each 25 - 30hrs ,compensate it if not e- nough. (4) the volume of antifreeze nixture should be 6 % less than the water, because the antifreeze mixture preventive liquid will exqands at high temperature. 3. Preparation for starting 3.1 The diesel engine should be thoroughly checked before starting. Closed attention en equipment is rigid and reliable, and whether the transmission parts and con- should be paid to see whether foundation bolts and the connection with the driv- trol systems are sensitive and so on.
The engine won't be started unless every- thing is all right. 3.2 Check and replenish the oil sump to keep the oil surface between the top and bottom carved line, fill up cooling water and fuel oil, open th~ switch of the fuel 3. 3 It is recommen.d to vent the air out of fuel system step by step as foUows: tank,check the fuel system for leakage and eliminate it if there is any. At first loosen the venting screw on the filter, pump the fuel with primiRg hand pump, vent out the air from the fuel passage between the fuel tank and the filter, then loosen the venting screw on the injectionpu01p until the fuel flows out without bubbles.
3.4 'Check the battery be sufficien or not, connect the battery to the circuit and see whether it is electrified. 4. starting The diesel engine shouldn't be started until the preparation is completed and meets the requirefllent. When starting, the clutch should be apart, operate as following 4. 1 Set the control handle of the fuel valve to the position where the fuel will be de- steps: livered rather more. 4.2 Turn the circuit switch clockwise and close the circuit. 4.3 Turn the starting switch to the" starting position" ,after the crankshaft is spee- ded up by the starting motor, the engine is started then. · 46·