Weichai — Weichai 495 Series Diesel Engine Operation and Maintenance Manual

4.5 Dismantle and check the cylinder head. Test the valve seal, wipe off the carbon deposit, burnish the. valve according. the conditions. 4.6 .Check the fasten situation of the cylinder head bolt, main bearing boa, connect- ing rod bolt. For the bolts which tightening torque is insufficient, then tighten it to 4.7 Check the water pump, replace the lubricating grease, if necessary, replace the the set point value. water seal. 4.8 Check the dynamo ,starting motor,clean,repair and fill new lubricationg grease. 4.9 Check the injection pump, adjust the fuel lead angle, and adjust the injection 4.

10 Test the air co"mpressor, burnish the valve according the situation, and clean the pump according the conditions. carbon deposit. 4. 11 Check the clutch, clean the inside dust deposit, oil dirt, and replace the lubrica- ting grease. 4. 12 Check the turbocharger, clean the parts, wipe off the cabon deposit, and test the rotor freedom allowance. 5. Technique maintenance on winter using If the temperature maybe lower than5°C, the engine must be maintained specially. 5. 1 Must use the winter used oil and fuel, note the damp in the fuel so as to protect the fuel passage from being jammed.

5.2 It's better to .fill the antifreeze fluid to the cooling system, or must drain off the 5.3 On the cold dseason or area, it's better to prevent the diesel engine ( or vehicle cooling water after its lemperature is lower than 40 -50CC. from being deposit in the open air, or when starting, it's need to heat the cooling water to preheat the engine body. CHAPTER V Troubleshooting 1. Start failures Touble cause and its feature Remedy 1.1 Troubles in fuel system 1. 1 ( 1) Jammed in the fuel s ( 1) DisrT)antle and clean 51