Komatsu — 250 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication and Service - Section 40 OM4051 Page 40-12 250 HOUR LUBRICATION AND MAINTENANCE CHECKS NOTE: “Lube Key” references are to the Lubrication Chart on page 40-8. Every 10 Hour (Daily) Inspection should also be performed at this time. 1. 2. 3. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS ENGINE - 1. Change the engine oil. Refer to the engine operation and maintenance manual for engine oil specifications. (Lube Key A) NOTE:

If the engine is equipped with the Centinel™ oil system and/or the Eliminator™ filter system, engine oil and filter change intervals are extended beyond 250 hours. Take an engine oil sample for analysis. Refer to the engine operation and maintenance manual for specific oil and filter change intervals. 2. If equipped, replace the engine oil filters. Follow the instructions of the filter manufacturer, which are normally printed on the outside of the filter. Do not use a wrench or strap to tighten filter elements. 3. Check the tension and condition of each accessory drive belt. Refer to the engine operation and maintenance manual for specific adjustment instructions. 4.

Check the torque on the cooling fan mounting capscrews. Tighten to 237 N•m (175 ft lb). COOLING SYSTEM - 1. Check for proper coolant mixture. Add coolant as required. Refer to Cooling System Service on page 40-2. 2. Change the coolant filters. NOTE: Refer to the engine operation and maintenance manual for proper coolant mixture specifications and coolant filter replacement instructions. 3. Check the cooling system hoses for damage and deterioration. Replace as necessary. FUEL FILTERS - Change the fuel filters. Refer to the engine operation and maintenance manual for specific filter replacement instructions.