Komatsu — 500 HOUR LUBRICATION AND MAINTENANCE CHECKS

Lubrication and Service - Section 40 OM4051 Page 40-14 500 HOUR LUBRICATION AND MAINTENANCE CHECKS Every 10 Hour (Daily) Inspection and 250 Hour Lubrication and Maintenance Check should also be performed at this time. NOTE: “Lube Key” references are to the Lubrication Chart on page 40-8. 1. 2. 3. 4. 5. 6. 7. 8. 9. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS HYDRAULIC SYSTEM FILTERS - Replace the hydraulic tank breathers and high pressure filter elements. Check the oil level. Add oil as necessary.

(Lube Key B) HYDRAIR® SUSPENSION - Check for proper piston extension (front and rear). THROTTLE AND BRAKE PEDAL - Lubricate the treadle roller and hinge pins with lubricating oil. Lift the boot from the mounting plate and apply a few drops of lubricating oil between the mounting plate and the plunger. HOIST LEVER LINKAGE - Check the lever operation. Clean, lubricate and adjust the linkage as necessary. PARKING BRAKE - Refer to the shop manual for the recommended inspections. RESERVE ENGINE OIL SYSTEM - 1. Check the electrical system connections for tightness, corrosion and damage. Check the battery, oil pressure switch, junction boxes, remote control box and the circuit breakers. 2.

Examine all electrical cables over their entire length for possible damage. 3. Inspect all reserve engine oil system hoses for leaks, cracks or other damage. Check all fittings for tightness, leakage or damage. BLADDER ACCUMULATORS - Check the precharge pressure. Failure to maintain the correct precharge pressure may result in bladder failures. VHMS DATA DOWNLOAD - Perform a data download from the VHMS controller and send the data to WebCARE. Refer to the shop manual for more detailed instructions. GRID BLOWER SHAFT BEARINGS - Add one or two applications of grease to each grease fitting. Ensure that each bearing is receiving grease. Replace bearings if any wear is detected. (Lube Key G)