OM3224 Operator Cab And Controls - Section 32 Page 32-3 Dynamic retarding is a braking torque (not a brake) produced through electrical generation by the wheel motors when the truck motion (momentum) is the propelling force. PEDALS Retarder/Service Brake Pedal Retarder/service brake pedal (3, Figure 32-1) is a single, foot-operated pedal that controls both retarding and service brake functions. The first portion of pedal travel commands retarding effort through a rotary potentiometer. The second portion of pedal travel modulates service brake pressure directly through a hydraulic valve.
Thus, the operator must first apply, and maintain, full dynamic retarding in order to apply the service brakes. Releasing the pedal returns brake and retarder to the OFF position. Dynamic retarding is available in FORWARD/ REVERSE at all truck speeds above 0 mph/kph. However, as the truck speed slows below 3 mph (4.8 kph), the available retarding force may not be effective. Use the service brakes to bring the truck to a complete stop. Dynamic retarding will not hold a stationary truck on an incline.Use the parking brake or wheel brake lock for this purpose. When the pedal is partially depressed, the dynamic retarding is actuated.
As the pedal is further depressed to where dynamic retarding is fully applied, the service brakes (while maintaining full retarding) are actuated through a hydraulic valve which modulates pressure to the service brakes. Completely depressing the pedal causes full application of both dynamic retarding and the service brakes. Indicator light (8, Figure 32-8) on the instrument panel will illuminate, and an increase in pedal resistance will be felt when the service brakes are applied. When in NEUTRAL, dynamic retarding is available only when truck speed is above 3 mph (4.8 kph). When dynamic retarding is in operation, engine rpm will automatically go to an advance retard speed setting.
This rpm will vary depending on temperature of several electrical system components. Dynamic retarding will be applied automatically if the speed of the truck obtains the maximum speed setting programmed in the control system software. When dynamic retarding is activated, an indicator light in the overhead display will illuminate. The grade/speed retard chart should always be used to determine safe downhill speeds. Refer to Grade/ Speed Retard Chart on the next page. For normal truck operation, dynamic retarding (lever or foot-operated pedal) should be used to slow and control the speed of the truck.
The service brakes should be applied only when dynamic retarding requires additional braking force to slow the truck speed quickly or when bringing the truck to a complete stop. Throttle/Accelerator Pedal Throttle/accelerator pedal (3, Figure 32-1) is a foot- operated pedal which allows the operator to control engine rpm. It is used by the operator to request torque from the motors when in FORWARD or REVERSE. In this mode, the propulsion system controller commands the correct engine speed for the power required. In NEUTRAL, this pedal controls engine speed directly. Do not LIGHTLY apply the retarder/service brake pedal when attempting to slow the truck on a downhill grade.
Overheating of the brakes will result. FULLY apply the brake pedal within safe limits for road conditions.