OM3224 Operator Cab And Controls - Section 32 Page 32-17 Indicator light (4, Figure 32-8) will illuminate to indicate that a fault has occurred which has eliminated the propulsion capability. If this condition occurs, the operator should safely stop the truck, move the directional control lever to PARK, shut down the engine, and notify maintenance personnel immediately. No Propel Wheel Brake Lock Applied Indicator light (8, Figure 32-8) will illuminate when the wheel brake lock is on. The wheel brake lock should only be used when the truck is completely stopped and in loading position. Traction Control Engine Warming Up Indicator light (5, indicates that the until the indicator goes out.
ate for up to three minutes. Engine Delay will remain running. Grid Drier Indicator light (7, parked in rainy conditions. Indicator light (9, Figure 32-8) will illuminate when the traction control Figure 32-8) switch is in the OFF position. This engine oil feature should always be used when yet at normal conditions are wet or slippery. perature. The erate the truck out. Repair Monitor Indicator light (10, Figure 32-8) will illuminate if a “repair” fault is detected, which must be corrected ch has been after the operator’s shift is done. tain conditions dicator light (6, nate to indicate Snapshot ing sequence ne could oper- Indicator light (11, Figure 32-8) utes.
indicates that the VHMS system is in the process of recording a control lever is moved out of “snapshot” of certain vehicle will stop immediately. conditions. s turned back ON, the engine be terminated, and the engine . Figure 32-8) drier feature is ture is used to when starting een washed or