Komatsu — 3.13.1 ORGANIZING THE WORK AREA

USING THE WORK EQUIPMENT 3.13 USING THE WORK EQUIPMENT 3.13.1 ORGANIZING THE WORK AREA If after a first inspection the area results to be uneven, encumbered with big obstacles or characterized by consid- erable height differences, before starting work it is advisable to level the ground as much as possible, both for the machine and for the vehicles to be loaded. This preliminary operations will make work quicker, ensure better results and at the same time reduce the opera- tor’s stress and the straining of the machine components; furthermore, this will considerably reduce the time nec- essary to carry out the excavation or to load the trucks destined to the transport of the material.

The area to be cleared from obstacles requires the use of a truck positioned as indicated in the figure; for any oth- er arrangement the movements of the loader must be reduced as much as possible. 115 WARNING • Always fasten the safety belt before any manoeuvre. • Before starting work, warn the persons in the vicinity by means of the horn positioned on the right le- ver. • If due to a sudden failure the machine stops with raised equipment, turn the ignition key to position « », release the safety device, gradually operate the boom lowering control lever until the bucket rests on the ground and release any residual pressure.

IMPORTANT • The basic illustrations shown are those necessary for a correct use and exploitment of the machine; the operator must get to know the controls, the described operating method and learn how to organize work in a free area while seated in the driving position.