Komatsu — 3.13.4 CHANING THE BUCKET

USING THE WORK EQUIPMENT 118 3.13.4 CHANGING THE BUCKET WARNING   • When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet. • The change of the equipment must be carried out by two   persons, who must decide together the words and signals to use during operations. • Do not use your fingers to center the holes, since they may be injured or even cut in case of sudden or uncon-  trolled movements. • The described procedures are valid also for the coupling of the mechanical constraints of the optional equipment. 1 - Position the bucket on a level surface, directing it so that the flat part of its back rests on the ground.

2 - Remove the tie rod pin (1) and the arm connection pin (2). 3 - Change the bucket, taking care to clean the pins, the bush- ings and the seals perfectly and to grease the pins slightly before reinstalling them. IMPORTANT • Install first the arm connection pin, making sure that the seals are in good conditions. 4 - Put back all the safety pins (3) and lubricate by means of the appropriate grease nipple.      WARNING • When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet. • The change of the equipment must be carried out by two persons, who must decide together the words and signals to use during operations.

• Do not use your fingers to center the holes, since they may be injured or even cut in case of sudden or uncon- trolled movements. • The described procedures are valid also for the coupling of the mechanical constraints of the optional equipment. 1 - Position the bucket on a level surface, directing it so that the flat part of its back rests on the ground. 2 - Remove the tie rod pin (1) and the arm connection pin (2). 3 - Change the bucket, taking care to clean the pins, the bush- ings and the seals perfectly and to grease the pins slightly before reinstalling them. IMPORTANT • Install first the arm connection pin, making sure that the seals are in good conditions.

4 - Put back all the safety pins (3) and lubricate by means of the appropriate grease nipple.