USING THE MACHINE WITH VARIABLE TRACK GAUGE 3.14.2 ADJUSTING THE BLADE The machine with variable track gauge is equipped with adjust- able blade and the positions available are two: 1 A -Standard position Blade width: 1000 mm (40 in) 1000 (3'3") RWA32870 B -Max. extension position: Blade width: 1320 mm (52 in) 1 1320 (4'4") RWA32880 The blade width can be modified by proceeding as follows: 1 - Stop the machine on a level surface, lower the equipment to the ground and stop the engine. 2 - Remove the bolts (1) that fasten the extensions positioned at the blade ends.
3 - Invert their positions, right extension on the left side and left extension on the right side, put back the fastening bolts and tighten according to the prescribed driving torque (see ”4.4.1 STANDARD DRIVING TORQUES”). 120