NUT AND BOLT TIGHTENING TORQUES 4.4 NUT AND BOLT TIGHTENING TORQUES 4.4.1 STANDARD TIGHTENING TORQUES 4.4.2 SPECIFIC TIGHTENING TORQUES 140 # Nm (Newton metre):
1 Nm = 0.102 kgm (0.738 lb ft) Thread diameter (mm) Pitch (mm) wrench size (mm) 8.8 10.9 kgm Nm lb ft kgm Nm lb ft 6 8 10 12 14 1 1.25 1.5 1.75 2 10 13 17 19 22 0.96 ± 0.1 2.3 ± 0.2 4.6 ± 0.5 7.8 ± 0.8 12.5 ± 1 9.5 ± 1 23 ± 2 45 ± 4.9 77 ± 8 122 ± 13 7 ± 0.74 17 ± 1.5 32 ± 3.6 57 ± 5.9 90 ± 9.6 1.3 ± 0.15 3.2 ± 0.3 6.5 ± 0.6 11 ± 1 17.5 ± 2 13.5 ± 1.5 32.2 ± 3.5 63 ± 6.5 108 ± 11 172 ± 18 10 ± 1 24 ± 2.6 47 ± 4.8 80 ± 8 127 ± 13 16 18 20 22 24 2 2.5 2.5 2.5 3 24 27 30 32 36 19.5 ± 2 27 ± 3 38 ± 4 52 ± 6 66 ± 7 191 ± 21 262 ± 28 372 ± 40 511 ± 57 644 ± 70 141 ± 15 194 ± 21 275 ± 30 377 ± 42 475 ± 52 27 ± 3 37 ± 4 53 ± 6 73 ± 8 92 ± 10 268 ± 29 366 ± 36 524 ± 57 719 ± 80 905 ± 98 198 ± 22 270 ± 26 387 ± 42 531 ± 59 668 ± 72 27 30 3 3.5 41 46 96 ± 10 131 ± 14 945 ± 100 1287 ± 140 698 ± 74 950 ± 103 135 ± 15 184 ± 20 1329 ± 140 1810 ± 190 980 ± 103 1336 ± 140 IMPORTANT • This driving torque table is not valid for screws or nuts that must lock nylon parts or alike onto washers or components made of nylon or nonferrous materials.
ITEM DESCRIPTION kgm Nm lb ft Engine Front support central screw Rear support central screw 5.5± 0.5 5.5 ± 0.5 54 ± 5 54 ± 5 40 ±3.6 40 ±3.6 Engine supports Screws for fastening to the engine 6.5± 0.5 64 ± 5 47 ±3.6