MAINTENANCE PLAN 4.7.1.f CHECKING THE RUBBER TRACK TENSION WARNING This operation must be carried out by two persons. One operator must sit in the cab and move the ma- chine according to the signals of the operator who carries out the check and the adjustment. The shoe tension must be checked with the frame lifted from the ground. Do not operate any control le- ver while the operator is carrying out the check. CHECK 155 Stop the machine on a firm and level surface, after resting the equipment on the ground. 1 - Position the joint of the rubber track marked with M on the up- per part of the track, mid-way between the two axes. 2 - Lift each track by means of boom and arm.
When carrying out this operation, move the control levers slowly. 3 - Measure the distance between the track and the third roller starting from the sprocket. If the distance is included between 10 and 15 mm (0.4 to 0.6 in), the tension is normal. If the clearance exceeds the standard value, adjust the ten- sion and restore the correct value. M 10-15 mm (0.4-0.6 in) RWA06610 RWA06380 RWA32910 M 10-15 mm (0.4-0.6 in) RWA06610 IMPORTANT • If the machine is operated with loose rubber tracks, the shoes may come off their seats and consequently off the track, or the steel reinforcement units may wear too quick- ly.