Removing and installing engine water pump Installing engine water pump Fig. 4 Clean the sealing faces on water pump and engine housing. Fit water pump with new seal. Fit the mounting bolts. 4 Fig. 5 Turn engine to ignition TDC, see page 24. Set delivery start indicator so that its measuring edge points exactly to the TDC point on the grad- uated scale. Tighten the mounting bolts to the specified torque. Screw coolant hose pipe on to oil cooler. Install short-circuit inserts / thermostats, see page 42. Fit and tighten V-belts, see page 120. Filling up with coolant, see page 41. 5 Note: Exchange or repair water pump only if it has been found to be leaky.
For design-related reasons small quantities of coolant may permeate through the mechanical seal on the water pump. This permeating coolant leaves a trace below the drain bore on the water pump. The water pump need not be exchanged or repaired because of this trace of permeating coolant. For this reason before exchanging or repairing a water pump ascertain D whether the coolant circuit shows visible and recurrent loss of water; if so D whether the loss of water is caused by coolant emerging from the expansion tank (e.g. over- filled) or by other leaks on hoses, etc.
Water pumps must be exchanged only if water drips visibly while the engine is in operation or after the engine has been switched off. 44