MAN — Removing and installing vibration damper, changing front crankshaft seal

Removing and installing vibration damper, changing front crankshaft seal Removing vibration damper D Relax and remove V-belt, see page 120 D Turn engine to ignition TDC. This ensures that in subsequent assembly work the indicating dial will be in the correct position. Fig. 1 Block the crankgear. The picture shows a special tool which is to be fitted to the inspection hole of the flywheel hous- ing. 1 Fig. 2 Remove cranking device. 2 Fig. 3 Loosen mounting bolts on vibration damper. 3 Fig. 4 Remove two bolts facing each other and replace them by two guide pins (M16 x 1.5). Remove all bolts. Remove vibration damper. Caution: The vibration damper is susceptible to shocks.

Take oil splash ring off crankshaft. 4 62