MAN — Removing and installing flywheel, replacing gear ring

Removing and installing flywheel, replacing gear ring Changing starter gear ring Fig. 5 Remove flywheel. Drill a hole in starter gear ring and snap it using a chisel. Caution: Take care not to damage the flywheel. 5 Fig. 6 Note: Since the maximum axial runout (lateral runout) of the starter ring gear must not be exceeded, the axial runout of the flywheel is to be measured on the contact face of the starter ring gear before the starter ring gear is shrunk on. Exchange flywheel if the value required is exceeded. Take up flywheel at hub. Apply dial gauge to contact face of ring gear. Turn flywheel by hand by several revolutions and observe the deflection shown on the dial gauge. 6 Fig.

7 Heat new starter gear ring up to approx. 200 _ C to 230 _ C and press on until it stops. Danger: The parts are hot. Risk of burns. Wear pro- tective gloves. 7 Check axial runout and compare with max. permissible value. 67