MAN — Removing and installing intake manifold

Removing and installing intake manifold Note: When carrying out work on the intake sys- tem, ensure meticulous cleanliness to pre- vent dirt and foreign matter from penetrat- ing into the system. Removing intake manifold Fig. 1 Remove the charge-air elbow and the charge-air pipes leading to the turbocharger. 1 Remove the injection lines, see page 31. Fig. 2 Remove the mounting bolts from the front end of the charge-air pipe. 2 Fig. 3 Remove the mounting bolts from the intake pipe. Take off intake pipe. 3 Installing intake manifold Fig. 4 Place intake manifold with new seals in position. Fit the mounting bolts. Ensure that the seals are correctly seated.

Tighten mounting bolts to the specified torque. Attach the injection lines. Fit the charge-air elbow and the charge-air pipes leading to the turbocharger. Exchange O-ring seals. 4 71