Removing and installing cylinder head Figs. 9 and 10 Tighten bolts by angle. Observe order of tightening and specified tighten- ing method, and see instructions and notes on the cylinder head bolts in the publication “Service Data”. Note: To avoid any distortion between cylinder heads and exhaust manifolds, we recom- mend proceeding as follows: D Place cylinder head gaskets and cyl- inder heads in position D Screw in head bolts by a few turns D Secure steel ruler (special tool) with ground face on the exhaust side; tightening torque for mounting bolts: 20 Nm. If a steel ruler is not available, mount exhaust manifold and tighten to 20 Nm.
D Tighten cylinder head bolts as speci- fied D Remove steel ruler 9 10 Installing the rocker arms and push rods Fig. 11 Check push rods for distortion. When inserting the push rods ensure that they fit into the seat of the valve tappet. Put rocker arms and push rods in place. Tighten the mounting bolts lightly and align the rocker arms to the valves. Tighten the mounting bolts to the specified torque. 11 Fig. 12 Set valve clearance, see page 83. Mount cylinder head cover with new seal. D Installing exhaust manifold D Installing intake manifold D Fit injection nozzle D Fill up with coolant 12 81