MAN — Setting valve clearance

Setting valve clearance Adjust the valves only when engine is cold (max. coolant temperature 50 ° C). Fig. 1 Remove cylinder head cover. Caution: Residual amounts of oil may emerge du- ring this operation. Used oil is dangerous waste. Observe safety regulations to prevent da- mage to the environment. 1 The speed pickup is fitted to the bottom right-hand side of the flywheel housing. Remove the mounting bolts from the retaining plate and take off plate to- gether with the speed pickup. 5 1 Use cranking device to turn engine until the piston of the cylinder to be adjusted is at ignition TDC and the rocker arms are relieved.

6 8 7 654 3 21 2 The valves of the synchronous cylinder are then in cross-over. 7 3 8 4 Fig. 2 2 D 2848 LE 2.. Set valves in the cylinder Valves are in cross-over in cylinder 6 1 7 2 8 9 10 8 7 6 5 4 3 2 1 3 Fig. 3 9 4 D 2840 LE 2.. Set valves in the cylinder 10 5 Valves are in cross-over in cylinder 3 Fig. 4 7 1 D 2842 LE 2.. Set valves in the cylinder 8 2 9 9 10 11 12 3 Valves are in cross-over in cylinder 10 8 76 54 32 1 4 12 11 5 6 4 83 1 5 7 2 6 3 4 8 6 3 4 8 1 5 7 2 1 6 5 10 2 7 3 8 4 9 7 3 8 4 9 1 6 5 10 2 1 12 5 8 3 10 6 7 2 11 4 9 6 7 2 11 4 9 1 12 5 8 3 10