MAN — Removing and installing valves

Removing and installing valves Removing valves Remove rocker arms. Take off cylinder head, see page 79. Fig. 1 Note: Valve spring and valve spring retainer can also be replaced with the cylinder head installed. For this purpose the relevant piston must be at TDC, and the valve assembly lever is required. 1 D Fit valve assembly lever to cylinder head D Screw in setting screw so that the lever points slightly upwards Fig. 2 Note: If a valve fixture is available in the work- shop, the procedure described may also be carried out on the said fixture.

2 D Press spring plate and spring downwards with valve assembly lever and take out the valve cone pieces using a magnet D Move assembly lever upwards − Caution: spring under tension, risk of injury − and away to one side Figs. 3 and 4 D Take off the upper spring plate, the valve springs and the washer D Turn cylinder head over.

Pull out inlet and ex- haust valves and put them aside, arranging or marking them in the sequence of installation D Turn cylinder head over again and pull off valve stem seal (arrow) D Check the valves for damage, if necessary ex- changing them D Measure the valve springs and exchange fati- gued springs D Check the valve stems and guides for scores and wear, if necessary measuring the guides with a plug gauge D Check the valve seats for heavy indentation or signs of burn-out, if necessary grinding the valves or exchanging the seat insert D Rework valve seat insert (see instructions of milling machine manufacturers), or if necessary exchange it 3 4 86