Kaiyi — 5. RCV LEVER

CROSS SECTION 3) 1 Case 2 Bushing 3 Spool 4 Shim 5 Spring 6 Spring seat 20 7 Spring 8 Plug 21 9 Push rod 10 O-ring 22 11 Rod seal 17 12 Plate 15 13 13 Spacer 14 Boot 16 23 15 Joint assembly 9 16 Swash plate 17 Adjusting nut 14 11 18 Bushing 12 19 Plug 18 8 20 Handle assembly 10 21 Handle bar 6 7 22 Nut 5 23 Boot 24 Last guard filter 4 25 O-ring 19 2 3 25 26 O-ring 1 27 Connector 27 300L2RL06 26 24 Item numbers are based on the type L1. The construction of the pilot valve is shown in the attached cross section drawing. The casing has vertical holes in which reducing valves are assembled.

The pressure reducing section is composed of the spool (3), spring (5) for setting secondary pres- sure, return spring (7), spring seat (6) and shim (4). The spring for setting the secondary pressure has been generally so preset that the secondary pressure is 5 to 20.5 kgf/cm 2 (depending on the type). The spool is pushed against the push rod (9) by the return spring. When the push rod is pushed down by tilting the handle, the spring seat comes down simultaneously and changes setting of the secondary pressure spring. 2-74