5.
MAIN RELIEF PRESSURE CHANGE CIRCUIT ARM CYLINDER BUCKET CYLINDER BOOM CYLINDER SWING MOTOR ps1 T3 T4 ps2 T1 T2 TRAVEL MOTOR pa11 pa10 DR1 pc1 pb9 A5 B5 pb5 B9 A9 TURNING JOINT pa5 ARM1 ARM2 pc1 pb9 (34,2) PO A4 B4 B8 A8 pa5 pa9 (34,1) P2 B A A1 B1 DR7 OPTION BUCKET DR2 pa11 pb8 pa8 Auto power boost pc7 A3 B3 pc2 A7 B7 pc2 A2 B2 pa3 pb3 BOOM2 BOOM1 pb3 pb7 pa3 pa7 pc7 DR3 pc6 pa2 pb2 SWING pc6 TRAVEL-RH pb6 A6 B6 A1 B1 pb1 pa6 pa1 pr1 TRAVEL-LH STRAIGHT TRAVEL RCV PEDAL P T TRAVEL PT PS P1 P2 PH PA PP PS SH P3 pa6 pb6 pb1 pa1 (4) (1) (2) (3) SWING ARM BUCKET BOOM P T P T Dr#, dr# A1 A2 POWER MAX SOLENOID VALVE FRONT PUMP REAR PUMP PILOT PUMP (4) (1) (2) (3) (4) (1) (2) (3) Pk (T/Joint) PH (MCV) a b d e f g h j c d1 h1 PS PS PS A5 A1 A2 A3 P4 PG (S/Motor) pb5 pa2 pb2 pa9 pb8 pa8 pa7 pb7 h2 T(dr1) P3 P2 P1 PP(MCV) HYDRAULIC TANK RELIEF VALVE LINE FILTER 900L3HC06 When the power max switch on the left control lever is pushed ON, the power max solenoid valve is actuated, the discharged oil from the pilot pump flow into PH port of the main relief valve of main control valve ; Then the setting pressure of the main control valve is raises from 330 kgf/cm 2 (4690 psi ) to 360 kgf/cm 2 (5120 psi ) for increasing the digging power.
And even when press continuously, it is canceled after 8 seconds. When the auto power boost function is selected to enable on the cluster, the pressure of the main relief pressure is automatically increased to 360 kgf/cm 2 (5120 psi ) as working condition by the MCU. It is also operated maximum 8 seconds. 3-10