5. BUCKET IN OPERATION ARM CYLINDER BUCKET CYLINDER BOOM CYLINDER SWING MOTOR ps1 T3 T4 ps2 T1 T2 pa10 B9 A9 TRAVEL MOTOR pb9 (34,2) A8 B8 pa5 pc1 pa9 (34,1) P2 DR2 pa11 pb8 pa8 TURNING JOINT pc2 A7 B7 pc2 pb3 pb7 pa3 pa7 pc7 pc6 pb6 A6 B6 pa6 P3 A1 A2 FRONT PUMP REAR PUMP PILOT PUMP HYDRAULIC TANK 900L3HC14 When the RH control lever is pulled left, the bucket spool in the main control valve is moved to the roll in position by the pilot oil pressure from the remote control valve. The oil from the A2 pump flows into the main control valve and then goes to the large chamber of bucket cylinder.
The oil form the A1 pump flows into the large chamber of bucket cylinder through confluence oil passage in the main control valve by bypass cut pilot pressure (pa11). At the same time, the oil from the small chamber of bucket cylinder returns to the hydraulic oil tank through the boom spool in the main control valve. When this happens, the bucket rolls in. The excessive pressure in the bucket cylinder head side is prevented by relief valve. The cavitation which will happen to the head side of the bucket cylinder is also prevented by the make-up valve in the main control valve.
3-16 1 1 1 Relief valve ARM2 BUCKET B5 A5 pb9 pb5 ARM1 pa PO B A B B1 A A1 DR pc A3 B3 pb 5 4 4 OPTION 7 7 3 B2 pa3 BOOM2 A2 pb2 SWING DR3 pa2 pc6 B1 A1 pb1 pa1 TRAVEL-LH pr1 P1 PSPT PP PA P SH PS 3 BOOM2 2 SWING 3 2 6 1 1 TRAVEL-LH BOOM1 TRAVEL-RH STRAIGHT TRAVEL