Kaiyi — 2. ELECTRICAL CIRCUIT

1. POWER CIRCUIT The negative terminal of battery is grounded to the machine chassis through master switch. When the start switch is in the OFF position, the current flows from the positive battery terminal as shown below. GND :

Ground 4-7 1) 2) OPERATING FLOW Battery Battery relay Circuit breaker [CN-60] Master switch [CS-74A] Fuse box [No.1] Engine EMS interface [CN-16 (1)] Fuse box [No.2] Engine EMS interface [CN-16 (4)] Fuse box [No.3] Engine VGT/SCR lmap [CN-2 (1)] Fuse box [No.4] Engine SCR/EGR interface [CN-3 (1)] Fuse box [No.5] I/conn [CN-5 (59)] I/conn [CN-10 (3)] Room lamp [CL-1 (2)] Door switch [CS-1] Radio & USB player [CN-27A (8)] Fuse box [No.6] MCU [CN-51 (1)] MCU [CN-52 (8)] MCU [CN-53 (1), (25)] Fuse box [No.7] Master switch [CS-74B] l/conn [CN-5 (36)] Start switch [CS-2A (1)] RMS [CN-125A(1)] RMS connection [CN-125 Power relay [CR-35 (30)] Fuse box [No.8] l/conn [CN-11 (5)] AC & Heater controller A (7) Blower relay (4) Fuse box [No.9] I/conn [CN- 5 (18)] I/conn [CN -17 (5)] Wiper motor controller [CN-141 (7)] Wiper motor [CN-21 (4)] Fuse box [No.10] I/conn [CN-5 (11)] Cluster [CN -56 (1)] Hour meter [CN-48 (1)] I/conn [CN-8 (6)] Haptic [CN-363 (2)] ※ I/conn :

Intermediate connector CHECK POINT Engine Start switch Check point Voltage STOP OFF ① - GND (battery 1EA) ② - GND (battery 2EA) ③ - GND (battery 2EA) ④ - GND (fusible link) 10~12.5V 20~25V 20~25V 20~25V