4-9 2. STARTING CIRCUIT 1) OPERATING FLOW Battery (+) terminal Battery relay [CR-1] Circuit breaker [CN-60] Master switch [CS-74A] Fuse box [No.7] Master switch [CS-74B] I/conn [CN-5(36)] Start switch [CS-2A(1)] (1) When start key switch is in ON position Start switch ON [CS-2A (2)] I/conn [CN-5 (39)] Battery relay [CR-1] Battery relay operating (all power is supplied with the electric component) l/conn [CN-4 (4)] Emergency engine stop sw [CS-33 (2)→(1)] l/conn [CN-4 (13)] Fuse box [No.
11] Engine EMS interface [CS-16 (3)] Start switch ON [CS-2A (3)] RMS conn [CN-125 (2)→(4)] I/conn [CN-5 (40)] Power relay [CR-35 (86)→(87)] Fuse box [No.12] MCU [CN-51 (2)] I/conn [CN-427 (1)] I/conn [CN-125A (2)] (2) When start key switch is in START position Start switch START [CS-2A (6)] I/conn [CN-5 (35)] Coutact input relay [CR-5 (1)→(3)] MCU [CN-51 (25)] ECM control Start relay [CR-23(1)] Starter operating 2) CHECK POINT Engine Start switch Check point Voltage OPERATING START ① - GND (battery) ② - GND (start key) ③ - GND (battery relay M4) + ④ - GND (starter B ) ⑤ - GND (starter M) ⑥ - GND (start relay) ⑦ - GND (battery relay M8) 20~25V