Kaiyi — 7. ENGINE OVERHEAT PREVENTION system

GROUP 7 ENGINE OVERHEAT PREVENTION system Main control valve Engine ECM CAN #1 Pump power shift EPPR Main pump Pilot pump Emergency warning lamp Cluster MCU Drive signal Hydraulic temp signal Hydraulic temp sensor Haptic controller CLUSTER AIRCON OFF Overheat warning signal CAN #1 & #2 CAN #2 Hydraulic temperature warning lamp 900L5MS18 1. If the engine coolant temperature or the hydraulic oil temperature is overheated over 103 C or 100 C , the warning lamp is ON and the pump input torque or the engine speed is reduced as below logic table. 2. LOGIC TABLE 5-10 Description Condition Function First step warning Activated - Coolant temperature : Above 103˚C - Hydraulic oil temperature :

Above 100˚C - Warning lamp : ON , buzzer : OFF - Pump input torque is reduced. - Warning lamp & buzzer : ON - Pump input torque is reduced. Canceled - Coolant temperature : Less than 100˚C - Hydraulic oil temperature : Less than 95˚C - Return to pre-set the pump absorption torque. Second step warning Activated - Coolant temperature : Above 107˚C - Hydraulic oil temperature : Above 105˚C - Emergency warning lamp pops up on the center of LCD and the buzzer sounds. - Engine speed is reduced after 10 seconds. Canceled - Coolant temperature : Less than 103˚C - Hydraulic oil temperature : Less than 100˚C - Return to pre-set the engine speed. - Hold pump absorption torque on the first step warning.